Wire Length 60mm 10.5-15V Dc Input Compact Size Dimmable DC Motion
Sensor
Features of Sensor:
1. Output: 0-10V dimming sensor; Operating Current＜30mA;
2. 360° detection angle when ceiling mounted;
3. Narrow / Wide detection area options;
5. -40~80℃ working temperature to support different environment;
5. Sensor size 66*20.5*12.1mm
6. With connector to make it easier to be connected with the LED
driver. Save time.
Product Description of Sensor:
| Warranty | 5 years |
| Stand-by power | ≤0.5W |
| Operating current | <30mA±5% |
| Control method | DIM/1-10V / remote control |
| Microwave frequency | 5.8GHz±75MHz |
| Operating voltage | 10.5-15V DC (supply current>50mA) |
| Microwave power | <0.3mW |
| IP grade | IP 20 |
| Operating temperature | -40°C~+80°C |
Mechanical structure of Motion Sensor:
| Detection area | Narrow/ Wide |
| Hold time | 30s/1min/2min/5min |
| Daylight threshold | 50Lux/Disable |
| Stand-by period | 0s/1min/5min/∞ |
| Stand-by dimming level | 10%/30% |
Dimensional drawing (Unit: mm) of Motion Sensor:
Compact size suitable for all kinds of lamps.
Wiring diagram of Motion Sensor:
| Control method | On/off / 1-10V dimming/remote control |
| Microwave frequency | 5.8GHz±75MHz |
| Operating voltage | 10.5-15V DC (supply current>50mA) |
| Wire color | White:12V,Purple:Dim+,Gray:Dim- |
Detection coverage of Motion Sensor:
This figure indicates the maximum distance at the highest mounting
height with 100% sensitivity.
| Mounting height | 4.8m/15.74ft (ceiling mounted) |
| Detection range | W: +/-5' Radius；N: +/-2.5' (ceiling mounted) |
| Detection angle | 360°(ceiling mounted); <150° (Wall Mounted) |
| Motion detection | 0.5~1.5m/s |
Installation of DC motion sensor:
3 pin connector,plug and plug,very easy to install and easy to use
by end customer.
| Installation precautions of motion sensor | 1. Microwave sensor can be installed in any lamp except the one
with full metal shell. |
| 2. The detected surface cannot be shielded by metal objects. |
| 3. Make sure the microwave module is completely exposed outside. |
| 4. The detection surface of the sensor module shall be installed
facing the detection area. |
| 5. Should be kept away from the driver to avoid interference
generation and lamp flashing. |
| 6. Wiring must be strictly in accordance with the wiring diagram to
avoid short circuit. |
Suitable for ceiling light, troffer, triproof light, batten light,
linear light, LED tube and etc.
US002-01VR-1,-2.pdf
