1. Automatically ON/OFF function:
| With sufficient daylight,even when motion detected,light remains
OFF. |
| With insufficient daylight,when motion detected, light ON. |
| After the last detection and the present hold time elapsed, light
OFF. |
2. No daylight function
When the daylight threshold is set to "Disable".
Light on when detect movement, After people leave, Light off after
stand-by period.
Applications: Dim places such as Basement Parking, Underpass.
| When motion is detected, the sensor will switch on the light to
100% brighteness. |
| After people leave the detection area, light remains 100%
brightness within hold time. |
| After the last detection and the present hold time elapsed, light
OFF. |
| With sufficient daylight,even when motion detected,light remains
OFF. |
| With insufficient daylight,when motion detected, light ON. |
| After last detection, the light will be dimmed down to the stand-by dimming level (10%,20%,30% or 50%) after holdtime. |
| After the stand-by period, light OFF. |
Features of ON/OFF Sensor:
1. Most popular DC sensor, especially for industrial lighting
fixtures
2. With daylight function, offer one more option for customer
except the motion sensor
3. Offer 6m mounting height, suitable for tri-proof light, linear
light in warehouse, tunnel
4. HD03R/HD05R remote control, support any options needed
5. 30min hold time and +∞ stand-by period options offer the most
proper mode for any applications
6. 10~ 50% stand-by dimming level offer flexible brightness needed
7.Two installation holes/rear clip-type way/double-face foam tape
offer different installation method for the end-users
Installation Method of DC Sensor:
1. Microwave sensor can be installed in any lamp except the one
with full metal shell.
2. The detected surface cannot be shielded by metal objects.
3. Make sure the microwave module is completely exposed outside.
4. The detection surface of the sensor module shall be installed
facing the detection area.
5. Should be kept away from the driver to avoid interference
generation and lamp flashing.
6. Wiring must be strictly in accordance with the wiring diagram to
avoid short circuit.
