Light Switches Dimmable Motion Sensor Remote Control Setting
suitable for panel light
Features
- 0-10V dimming suitable for indoor use
- Easy installation suitable for LED panel light
- Microwave motion sensor with remote control
- 5 years warranty
Parameter Table
| Operating voltage | 120~277VAC 50/60Hz |
| Switching capacity | Max:200W(120Vac),Max:400W(240Vac) |
| Stand-by power | <1W |
| Detection area | 50%/100% |
| Hold time | 5s/30s/1min/5min/10min/20min/30min |
| Daylight threshold | 2Lux/10Lux/30Lux /50Lux/80Lux/120Lux/Disable |
| Stand-by period | /10s/30s/1min/5min/10min/30min/+∞ |
| Stand-by dimming level | 10%/20%/30%/50% |
| Microwave frequency | 5.8GHz±75MHz |
| Microwave power | <0.3mW |
| Interfaces | 6-pole pluggable clamp terminal (L,N,N,L’,1-10v+,1-10v-) for 0.75-
1.5mm2 cable |
| Mounting height | Max.6m(ceiling mounted);Max.3m(wall mounted) |
| Detection range | Max.ø14m(ceiling mounted);Max.10m(wall mounted) |
| Detection angle | 30°-150° |
| Operating temperature | -25°C~+60°C |
| IP rating | IP20 |
| Life time | 50,000 hours |
| Warranty | 5 years |
Working with HD03R remote control.
Default Program:
Detection Area - 100%
Holdtime - 5S
Daylight Threshold - disable
Standby Period - 0S
Standby Dimming Level - 10%
Performance
* Daylight Priority
With Daylight priority function, HD410VR is able to differentiate
artificial light brightness from natural light after installed
inside the fixture, and automatically turn off light when ambient
brightness exceeds preset lux level.
* Daylight Threshold
With sufficient daylight, even when motion detected, light remains
OFF.
* Bi-Level Dim
When motion is detected, the sensor will switch on the light to 100% brighteness.
After people leave the detection area, light remains 100%
brightness for the hold time.
After holdtime, sensor dims light to standby dimming level (10% 20%
30% 50%) and keeps for a standby period.
After standby period,sensors turns OFF the light.
* ON/OFF
When motion is detected, the sensor will switch on the light to 100% brighteness.
After people leave the detection area, light remains 100%
brightness for the hold time.
Preset standby period as 0S, sensor turns OFF the light after
holdtime.
